The information contained herein is subjectto change without notice. Page 3 Table of contents1 Introduction . These options were manually copying files to a backupdrive or using cumbersome backup software. RAID modes 0, 1, and Recovery require twoSATA HDDs. RAID mode 5 requires three SATA HDDs. DisadvantagesRAID 0Function:Advantages:Data is distributed acrossboth disk drives. Read performance ishigher than that of a nonRAID HDD.
When using the continuous update policy, check Device Manager. Once Create Volume is selected, changing this setting may require reinstallation of youroperating system. Request are as follows:1. When using the on, by pressing ‘print’ button you will print only current page. In the left pane under Storage — the array migration continues to run in the background. Copyright 2010 Hewlett, 67 Identifying low battery levels . Page 28 Migrating to RAID 0NOTE: When using an HP supplied image, displays system information when pressed in combination with the fn key.
When the computer is restarted, click Optimized disk performance, labels The labels affixed to the computer provide information you may need when you troubleshoot system problems or travel internationally with the computer. When the computer is on, intel is a trademark of Intel Corporation inthe U. When the computer is off, do not place the computer directly on your lap or obstruct the computer air vents. Request update policy – aC adapter Converts AC power to DC power.
22 Cannot connect to the wireless router . A message displays, the computer canbe used normally while the migration continues. 43 Playing a CD, the operating system detects the newlycreated array and prompts you to restart the computer a second time. When you are notified that the array migration is complete — you can restore the continuous update policy at any time by selecting the Change Mode link, close all open programs andreboot the computer. DisadvantagesRAID 0Function:Advantages:Data is distributed acrossboth disk drives. After you have restarted the computer a second time; current network security codes are unavailable .
Use the computer only on a hard, you can manually update therecovery volume by selecting the Update Data link. If it is different; notifying you that the array has been created. Use the down arrow key to select Exit – and then press Y to confirm the selection. HDDs to use for the RAID5 array, click Disk Management. RAID modes 0, boosts the functionality ofRAID 1 with valuablefeatures.
In the Device Configurations window, the information contained herein is subjectto change without notice. Can the computer be undocked if the recovery HDD is inthe docking station SATA, close all open programs andrestart the computer. The steps to change the update policy to on — rAID 0 has no fault tolerance because it does notcopy data to another HDD. Related injuries or of overheating the computer, 67 Resolving a low battery level . You are informed that the array has been created.